Defining Multiple Latch Signals for a Belt Encoder Defining Multiple Latch Signals for a Belt Encoder NOTE: This feature applies only to belt cameras. For example, multiple latch signals are not allowed if the configuration is used for a belt-latching configuration (such as locating multiple pallets with dif- ferent latch signals). For that case, you will need to split the latches into separate encoders for the Belt object The ACE software allow you to define multiple latch signals for a belt encoder controller connection. You can then configure the robot-to-belt calibrations to use a specific latch signal.
By doing so, you will have multiple robot-to-camera calibrations sharing the same relative robot-to-belt calibration. NOTE: By default, you do not need to set latch information. If you have one latch signal in the belt encoder controller connection, you do not need to do anything -- it will work, by default. Therefore, it is backward-compatible with the previous behavior. To define multiple latch signals for a belt encoder: 1. Open the Belt editor. For details, see Belt on page 809. 2. Verify that you have associated a controller with the belt encoder, as shown in the following figure. 3.
Specify the latch signals used by each camera (for example, camera 1 wires into 1001 and camera 2 wires into 1002). To specify the signal numbers, double click the Input Number cell and then enter the desired signal numbers—multiple signals must be separated by a comma (1001, 1002, etc.). NOTE: The available latch signals are defined in the Robot section of the V+ System Con- figuration file. For details, see V+ System Configuration Editor on page 221. 4. Locate the robot-to-belt camera calibrations in the Sensor Calibration area of the Process Manager ACE User's Guide, 3.6.x 18316-000 Rev A Page 822