omron — Adding a Part Buffer to a Process

Adding a Part Buffer to a Process The Properties area changes to show the properties that can be used with a Static configuration. 2. Use the Properties grid to enter the buffer-location information. l Pallet Properties Optional. Specifies the pallet that is used to hold the part(s). Select the Enabled check box and then choose the pallet. After the pallet is specified, you can set the parameters for the pallet in the Process Pallet object editor. For details, see Process Pallet on page 927. 3. Now you can add the part buffer to a process, as described in the following section. Adding a Part Buffer to a Process To add a part buffer to a process: 1.

Add a Part Buffer object to your workspace, as described at the beginning of this topic. 2. Create a Part Buffer configuration. See the previous section for instructions. 3. Create a Process that includes a Robot, a Part and a Part Target. For details, see Processes on page 886. 4. Create a second process that includes the original Robot and Part, and select the Process Buffer as the Part Target. 5. Create a third process that includes the original Robot and Part Target, and select the Process Buffer as the Part. 6. Use the blue arrows in the Processes group to order the process by priority (the process at the top of the list gets the highest priority).

For details, see Processes on page 886. ACE User's Guide, 3.6.x 18316-000 Rev A Page 838