Configuration Items The Absolute option, when enabled, allows you to enter absolute Height values for the Approach and/or Depart motion segments. You can enter positive or negative values, as needed. WARNING: When the Abso- lute option is selected, you must ensure the approach/de- part heights are set correctly. Otherwise, the robot could move to an unintended loc- ation or out of range, which may damage the robot or other equipment in the work- cell. An I/O Timing parameter is included, which controls the timing of the gripper open/close during each part of the motion segment. The I/O Timing (Gripper On) can use either a % value or a distance value, as shown in the fol- lowing figures.
For example, if you set the value to 25 mm, the gripper will activate at 25 mm from the pick position; if you set it at 25%, the gripper will at 25% of the distance from the approach start to the pick position. The distance value is useful when accessing pal- lets with multiple layers and an absolute approach height has been specified. The time value allows you to set the gripper timing (in milliseconds). ACE User's Guide, 3.6.x, 18316-000 Rev A Page 861