omron — Control Sources

Control Sources Control Sources Editor - Belt Control Example ACE User's Guide, 3.6.x 18316-000 Rev A Page 870 Item Description Configurations Select the item in the Configurations list that you want to edit. Depending on the type of item selected, the options will change to show the appropriate control sources and options for that item. In this example, a conveyor belt (/Belt) has been selected - the available Controllers and Belt Control program options are displayed for that item. Cameras If there are multiple cameras defined in the workcell, these will appear as available cameras on the Cameras list. You can change the Vision Properties for the selected camera.

For details, see the description of Vision Properties. Controllers If there are multiple controllers defined in the workcell, these will appear as available controllers on the Controllers list. You can change the selected con- troller here, or you can change it in the Belt editor. Camera Mode There are two camera modes available: Distance and Trigger. When Distance is selected, the Field of View Picture interval control is enabled; when Trigger is selected, the Trigger Signal control is enabled. When emulation mode is enabled, an additional setting (Trigger Period in Emulation Mode) is displayed. This allows you to specify the trigger period in millimeters.

For more details on emulation mode, see Emulation Mode on page 1089.. Field of View Picture This control is used to adjust the picture interval relative to belt travel. The