omron — Process Strategies

Process Strategies ACE User's Guide, 3.6.x, 18316-000 Rev A Page 885 Belt Control Parameters The Belt Control Parameters are displayed when the belt is selected in the Process Strategy Editor. The Belt Control Parameters group, shown in the following figure, is used to set the belt control parameters for the selected conveyor belt. These parameters can be set to determine when a conveyor belt is turned on or off. An optional speed control parameter is also provided. The decision point for the belt I/O control is based on the selected robot. If objects on the belt in the selected robot queue reach the specified thresholds, the belt will be turned off or the belt speed will be adjusted.

Belt Control Parameters For this screen, the parameters are: Item Description On/Off Control Specifies the On/Off control of the belt. There are three selections available: Do not control the belt: The belt is not controlled by the ACE software. (It can l be controlled by another source, such as a PLC, V+, or OPC.) Leave the belt always on: The belt is turned on when the process starts. l Control the belt: (Default) The belt is controlled by the ACE software. The belt l is turned on/off based on how full the queue is. Also, the belt is automatically