Editor Parameters Application Information There are three application information pages: Status and Instances, which provide feedback on the oper- ation of the selected application. To view an information page, click the corresponding tab. NOTE: When the robot is waiting for parts or part targets, a yellow warning condition is displayed on the Process Manager control. It shows what part or part target the robot is waiting for. If the robot is waiting because a process has not been selected, it shows a similar warning indicating that a process has not been selected. For details on selecting and running a process, see the next section Controlling an Applic- ation on page 925.
ACE User's Guide, 3.6.x, 18316-000 Rev A Page 923 Item Description Idle state Indicates the application is idle (not operating). Operating state Indicates the application is operating. Warning state Indicates a warning condition. The specific warning message is displayed on the Status tab. See the Status tab description (in the next section) for details. Error state Indicates an error condition. The specific error message is displayed on the Status tab. See the Status tab description (in the next section) for details. Clear Clears all Part and Part Target instances from the system. Cycle Stop Sends a signal to each robot to stop after the current process cycle has completed.
Each robot stops after it reaches the end of its current pro- cess, and then the following message is displayed: You can resume the robot(s) and process operations by clicking the Cycle Stop button. The Cycle Stop feature gives the capability to implement a variety of situ- ations. For example, you could click Cycle Stop and leave the system run- ning. When the system is in this state, all tracking is enabled. Therefore, you could either click Abort (which stops everything), or you could simply resume the current cycle by clicking Cycle Stop again.