Status/Error Codes ACE User's Guide, 3.6.x 18316-000 Rev A Page 932 Status/Error Codes This section describes the Process Manager status/error codes and their descriptions. Configuration errors are displayed as prompts in the Process Manager (note that the error code is not dis- played); runtime status/error codes and their descriptions are displayed on the Status tab of the Process Manager Control. For details on the Process Manager, see Process Manager on page 843. For details on the Process Manager Control, see Process Manager Control on page 920. Category Key Each code/message shown in the next section is marked with the corresponding category.
Note that some codes apply to more than one category. The categories are as follows: C Controller F Feeder R Robot P Process G Gripper PT Part / Part Target CV Camera / Vision Pa Pallet BE Belt / Encoder Cs Custom L Latch O Other Code and Description List The following table provides a listing of the Process Manager status/error codes and corresponding descrip- tions. The codes are listed in ascending order. Description Placeholders Some description in the table have "placeholders", such as '{0}', in the text. For example, in the following status code/description: -20112 '{0}' has not been calibrated to the spacing reference for belt '{1}'.
In the example above, the '{0}' refers to a name of the robot, and '{1}' refers to the name of the belt. Code Description C R G CV BE L F P PT Pa Cs O -20151 The Feeder is enabled but not selected. x -20150 The Feeder device is not properly configured x -20149 An incorrect sequence of latches was detected. Controller '{0}' reported a latch out of sequence. x x C Controller F Feeder R Robot P Process G Gripper PT Part / Part Target CV Camera / Vision Pa Pallet BE Belt / Encoder Cs Custom L Latch O Other -20112 '{0}' has not been calibrated to the spacing reference for belt '{1}'.