Editing the Motion Parameters Editing the Motion Parameters After you add the Vision Refinement Station to the pick-place process, you can optionally edit the motion parameters for the station. This is done using the Location Editors that are accessed from the Con- figuration Items group. For details, see Location Editor Types on page 858. Selecting a Refinement Mode The Vision Refinement Station has a Refinement Mode option that specifies the type of vision refinement that is applied to the part on the gripper. The Refinement Mode option is added to the Location Editor when editing the Configuration items for a Vision Refinement Station, as shown in the following figure.
Refinement Mode Option for a Vision Refinement Station The refinement can be done in one of two ways: l Move to camera: This is a "static" refinement, where the robot pauses at the Vision Refinement l Vision on the fly: This is an "in motion" refinement, where the robot passes through the Vision Station. Refinement Station without any pause in the robot motion. NOTE: The "Vision on the fly" mode will provide faster throughput, but may require more lighting (to achieve a fast shutter speed) than the "Move to camera" mode. To select the refinement mode for the Vision Refinement Station: 1. Create the Vision Refinement Station, as described at the beginning of this topic. 2.
Add the Vision Refinement Station to a pick-place process. 3. Select the Vision Refinement Station in the Configurations Items group of the Process Manager, and click Edit . The Location Editor opens. For details, see Location Editor Types on page 858. Because this is a Vision Refinement Station, the Refinement Mode options are included at the top of the Loca- tion Editor. 4. Select the desired refinement mode from the Refinement Mode options. The Configuration Items parameters change, based on the selected refinement mode. For details, see Configuration Items on page 856. ACE User's Guide, 3.6.x, 18316-000 Rev A Page 943