omron — To program the application:

Belt Camera Part Pick Sample Belt Camera Part Pick Sample After you select the application sample, you are ready for the setup and programming of the application. An interview wizard guides you through the process, as described below. The following instructions are provided as an example of a Process Manager belt camera pick and place application (in other words, a vision-guided pick from a conveyor belt and place to a static location). The steps for your application sample may vary, depending on the application sample selected in the previous section. However, this example will provide an overview of the basic steps for programming an application sample. What happens next?

You will use the interview wizard to: l Select the robot l Select the gripper l Select the belt (conveyor) encoder l Select the virtual camera l Teach the vision model The interview wizard will pause momentarily to create the objects and write the program code, then you will: l Calibrate the robot to the belt (Belt calibration). l Calibrate the robot to the belt camera (Sensor calibration). l Teach the process in the Process Manager. You will teach the Idle, Part (pick) and Part Target (place) positions. l Run the process using the Process Manager Control. To program the application: After you complete the introduction pages of the interview wizard, continue with the steps described below.

ACE User's Guide, 3.6.x 18316-000 Rev A Page 966