omron — To program the application:

To program the application: a. Use the handles to set the bounding box for the area where the part will be located. b. Click Run to check the operation of the model. c. Click Next to proceed. The interview wizard records the ROI information and opens the next page. 8. Teach the idle, part (pick) and part target (place) positions, as instructed by the interview wizard. a. Click the Pendant button and use the controls to move the robot to the desired position. b. Click Next to proceed. The interview wizard records the position information and opens the next page. 9.

At this point, the interview wizard steps you through the automated sensor calibration procedures, which calibrate the robot to the fixed-camera, along with the final steps for teaching the process. 10. After the Process teach steps have been completed, the Sample Completed page opens. Read the instructions and click Next to proceed. ACE User's Guide, 3.6.x 18316-000 Rev A Page 980