Online to Transfer Monitoring Monitoring Force On Force Off Force On Force Off Online to Transfer Program Check Program Check Online Edit Online Edit 12. Force On/Off Contacts/coils are forced on/off from CX-Programmer. Move the cursor to a contact or coil that you want to force on/off. Click the right mouse button. -> [Force] -> [On] mark indicates that the bit is now being forced on/off. Click the right mouse button. -> [Force] -> [On] Force Off/Cancel of bits/coils are enabled in the same way. Force Off/Cancel of bits/coils are enabled in the same way. Once bits/coils are forced on/off, the forced statuses are held until cancelled or the reverse procedures of on/off are taken.
The statuses do not change by an external input or the operational result of the program. Moreover, force operations are not enabled when the PLC is in the Run mode. Shortcut Key Ctrl+J: Force On Ctrl+K: Force Off Shortcut Key Ctrl+J: Force On Ctrl+K: Force Off 13. Displaying List of Forced-on/off Bits The bits forced on/off can be listed in a table. This function enables you to check the forced statuses of more than one bit at a glance. Display Project Workspace. [Alt] + 1 Double-click [Memory]. Click the [Address] tab. Double-click [Forced Status].