Self-diagnosis Fault code output MAN M(S) 5 EDC / MS 5 EDC a) Reset by “Ignition” Off / On (cold restart) b) Reset takes place automatically once the fault is rectified 23 Overview of flash codes Number of flashes Long Short Fault path Steady light fault Main- tained light Reset a) / b) see page 0 0 No fault stored 1 Drive stage selection yes b) 31 4 Engine speed sensing (rpm sensor) yes b) 32 5 Turbo pressure sensing yes b) 33 6 Control rod position sensing yes a) 34 7 Coolant temperature sensing yes b) 35 8 Resistor bank no b) 36 10 Fuel volume regulator monitoring yes a) 37 14 Engine speed sensing (auxiliary rpm sensor) yes b) 38 1 1 Turbo air temperature sensing yes b) 39 1 3 Battery voltage sensing no – 40 1 6 Processor coupling defective yes a) 41 1 7 Overrevving yes b) 42 1 12 Resistor bank yes a) 36 1 13 Control box no b) 43 1 15 CAN system yes b) 44 2 5 Main relay sticking no – 45 2 8 Atmospheric pressure sensing yes b) 46 2 13 TSC1-FM (setpoint selection) yes b) 47 3 2 EEPROM processor 1 error yes a) 48 3 3 EEPROM processor 2 error yes a) 49 3 8 Afterrunning not completed no – 50 3 9 Afterrunning watchdog error no b) 51 3 10 Control rod position sensor – loose contact no – 52 – – PBM interface no – 53 – – Redundant cut-out device (EHAB) no – 54