3.3. Operation Operation V-shaped loading Position the dump truck in such a way that the angle between the dump and the dump truck is approx. 60°. Fill the bucket and shake it. This leads to a better distribution of the cargo in the bucket and prevents that material falls down to the back. Drive the machine backwards from the heap and align the machine with the dump truck. Raise the bucket to its maximum height. Drive up forward to the dump truck and unload the material. If you keep the turning angle of the machine as small as possible, the work will be more efficiently. Piling up material Do not position the bucket in its maximum tip-in or dumping posi tion while piling up material.
Instead, use the required mining angle. The rear counterweight must not touch the ground. Working with the forklift truck attachment Operations with an forklift truck attachment on a wheel loader dif fer from operations with the bucket or a forklift truck. Take into account the following notes and the instructions indicated in the chapter "2.1. General safety measures" on page 2-2. (500 mm) 19.685 in Do not take up loads which are so high that you cannot see onto the route. 19.685 in Hold the fork tines of the forklift truck attachment as horizontal as possible when you take up the load. (500 mm) During the ride, hold the load as low as possible in order to have free sight onto the route.
75_156 Always drive slowly (speed range 1) with the load. The boom performs a semicircular stroke while performing the lifting movement. Raise the boom only immediately in front of the place at which you want unload to the height at which you want to unload. In such a way, you prevent that you damage the load while lifting it. Hold the forklift truck attachment as horizontal as possible while piling up. 3-64 WA90-5 – VEAM270100