Maintenance 5 Cleaning the radiator segments The radiator ribs have to be checked daily and cleaned if neces sary. 1. Stop the vehicle. 2. Lower the work unit onto the floor. 3. Set the drive direction switch into its neutral position 'N'. Apply the parking brake. 4. Press the "Fan Reversal" (1) switch and keep it pressed. 5. Press the gas pedal down entirely for 30 s. The engine is run ning at its max. speed. 6. Release the gas pedal. The engine is running at idle speed. 7. Release the "Fan Reversal" switch (1). 8. Switch off the motor and visually check the radiator ribs for impurities. 9. If the radiator ribs are still dirty, use compressed air or a jet of water to clean them.
G0065034A 1 NOTE Do not hold the compressed air nozzle or water nozzle too close to the radiator segments. Use no scrubber for cleaning since the plates may be damaged V-Belt, checking the condition Check the drive belt for fissures. Transversal fissures in direction of the belt width are permit ted. Longitudinal fissures in direction of the belt length crossing transversal fissures, missing parts, or damaged tissue layers are not permitted. In these cases, replace the drive belt. WA90-5 – VEAM270100 5-27