Maintenance 5 Water separator at the fuel filter – Draining water and dirt sediments 1. Keep a container ready for collecting the fluid from the water separator. 2. Unscrew the valve (1) at the bottom of the water separator by 4 rotations. 3. Drain off the water and dirt sediments until pure fuel flows out. 4. Screw the valve (1) tight again, clockwise. Do not pull the valve too tight, it could damage the thread! NOTE If you have drained more than 60 ml, it is recommended that you fill the filter with fuel to prevent problems when starting the motor. 1. Loosen the vent screw (1) on the injection pump. 2.
Move the pump button (2) on the fuel filter until there are no more bubbles in the fuel flowing from the vent screw. 3. Retighten the vent screw (1). Hand pump - Checking the oil level 1. The oil level in the hand pump is checked with the cab tipped down. 2. Remove the screw plug (1). 3. The oil level has to be up to the lower edge of the filling hole (arrow). 4. If required, add oil (cross-reference to the list of consum ables). 5. Replace the screw plug into the filling hole (1) and pull it hand-tight. WA90-5 – VEAM270100 5-31 WARNING WARNING 1