Maintenance 5 5.7.4. Maintenance after the first 250 operating hours Front and rear axle – oil change Frequent contact between used hydraulic oil and skin may cause skin lesions and other physical damage! Wear rubber gloves when changing the oil. Thoroughly wash off any hydraulic oil adhering to your skin. There is danger of severe accidents, if you perform mainte-nance work at a machine that has not been parked and secured correctly! Park the machine on a solid, even surface and secure it, before you start to perform maintenance work. Planetary gearing 1. Start engine.
Raise work unit and drive the machine until the drain plug (1) for the planetary gearing on the wheel where you want to change the oil has reached its lowest point. Switch off engine. Lower work unit and apply parking brake. 2. Place drip pan or container underneath the drain plug (1). 3. Unscrew drain plug (1) and drain oil into container. 4. Drive machine until the planetary gearing drain plug hole (1) is in a horizontal (3 o'clock") position. 5. Fill planetary gearing with oil until the oil reaches the lower lip of the drain plug hole (1). 6. Clean drain plug and attach clean, undamaged (or new) washer. 7. Screw drain plug in tight. 8.
Change oil in other wheels of the front and rear axle following the same procedure as described under no. 1 - 7 above. WA90-5 – VEAM270100 5-39 WARNING WARNING DANGER DANGER