5 Maintenance Transfer box – checking and refilling oil NOTE If the engine is not running, the oil level in the transfer box can significantly rise. Therefore, only check the gear oil level with the engine running idle at operating temperature. The gearshift assembly must be in neutral position. If you perform maintenance operations at a machine which is not properly parked and secured, severe acci dents may occur! Park the machine on firm, level ground and secure it before starting the maintenance operations. 1. For maintenance operations, park and secure machine as described in chapter ""5.1. Maintenance guide" on page 5-2" 2. Clean the screw plug (1) and the adjacent environment. 3.
Unscrew the screw plug. 4. Check the oil level. The oil level must be at the lower edge of the control drill hole of the screw. 5. If the oil level is too low, fill up with oil using the control drill hole of the screw (1). 6. Clean the screw plug and insert a new packing ring. 7. Re-tighten firmly the screw plug. 5-60 WA90-5 – VEAM270100 DANGER DANGER