SECTION 1 INTRODUCTION Page 4 INTRODUCTION The two following signs and text in italics are used throughout this manual to call your attention to important procedures or steps having influence on the right functioning of a machine. Failure to follow such instructions may result in the damage of a machine or affect machine life time. IMPORTANT: This sign and text in italics is used throughout this manual to call your attention to key problems for machine operation. Failure to follow such instructions may result in damage of a machine and heavy material losses. NOTE:
This sign and text in italics is used throughout this manual to call your attention to an important function having influence on the right functioning of a machine or for informational purposes. 1.2. SERIAL NUMBERS Fig. 1.2. Product Identification Number (P.I.N.) Fig. 1.3.Product Identification Number (P.I.N.) on RMF The product identification number (P.I.N.) is stamped on a plate attached to the front wall of the control console at the left hand side of the operator’s seat (Fig. 1.2). It is also stamped on the rear frame in the upper right hand corner under the fender (Fig. 1.3). TD-25H DRESSTA