SAFETY PRECAUTIONS SECTION 2 Page 7 OPERATION When leaving a machine unattended for any length of time, make sure the transmission shift lever is positioned and locked in neutral (N), the blade is completely lowered, the engine is stopped, the parking brake is applied, and the electric master switch is in the “off” position. If the machine is equipped with a cab make sure that the cab is locked. Before operating a machine read and know the Operator’s Manual and all Safety Product Graphic. The roll-over protective structure (ROPS) provides the operator’s protection in the event of machine rollover or upset.
This structure is designed to bend during a rollover to protect the operator from sudden impact loads. When operating a machine, look in the intended direction of travel to be sure personnel or allied equipment does not interfere with the machine work pattern. Never try to get on or off a machine while it is moving. A serious injury or death could result. Never shift the transmission into neutral (N) when traveling downhill. The machine may go out of control and a rollover could result or the transmission, torque converter or engine could be damaged when the transmission is again placed in gear. Always put the transmission in low range position before starting downhill.
Use the decelerator and brake pedal to slow the machine. Avoid side hill travel whenever possible. Drive straight up and down the slope. If the machine starts slipping sideways on a grade, turn downhill immediately. If possible avoid crossing obstacles such as ridges, rocks or logs. If you can't avoid them, reduce speed and ease over the obstacle at an angle. Machine's weight and the vibration it creates can cause the edge of a high wall to collapse. Keep your machine back from the edges of banks and excavations. If it cannot be avoided drive the machine at the straight angle to the edge.
Travel slowly in congested areas or on rough ground, slopes or near drop-offs or on snow, ice or slippery surfaces. Maintain a safe distance between your machine and other vehicles according to the condition of the road and load. Never hold the hydraulic controls in their extreme position after the equipment has reached its maximum travel. This could cause overheating of the hydraulic system. Do not adjust the seat position while the machine is in motion. A loss of control may result. Completely stop the machine, apply and lock the parking brake and then adjust the seat. Never use the blade as a brake except in an emergency. Carry the blade low for maximum stability and visibility.
Where noise exposure exceeds the levels defined by proper health and safety authorities and applicable standards wear authorized ear protective equipment. DRESSTA TD-25H