POWER TAKE OFF 00-31 Legend 1. Push in 2. Pull out 3. Dump cable 4. Dump lever 5. Loosen When the fall time is improper or when the dump lever is hard to lock at “Up” time or when the shaft rotates forward at “Down” time, move the inner ca- ble to Direction (1) of the drawing on the preceding page. Notice: If the cable is adjusted on the dump lever side, be sure to re-inspect the amount of spool extrusion. After adjustment, tighten the lock nut at a specified torque. NPA0068E Legend 1. Oil pump 2. PTO 3. Direction of forward rotation 4. Direction of backward rotation 5. Shaft (drive shaft) Tighten:
Lock nut to 6 N m (0.6 kg m / 52 lb in) *Selector The selector is adjusted so that the ejection direction of the cargo deck can be selected only at dump lever “Down”. If this adjustment is improper, the cargo deck may slide from the truck at rise. Accordingly, because the adjustment of the selector main unit is also needed after the replacement, adjustment, and inspection of the control cable, request a nearest service network (SS store) of a body builder of the adjustment. 4. If a defect is found as a result of the inspection of the aforementioned items 1) to 3), adjust the con- trol cable in the dump lever portion inside the cab according to the following procedure.
1) Set the dump lever to the “Down” position. 2) Loosen the lock nut of the control cable and ad- just the cable as follows: When the rise time is improper or when the dump lever is hard to lock at “Down” time, move the inner cable to Direction (2) of the drawing on the preced- ing page. NPA0069E