00-34 POWER TAKE OFF Legend 1. Oil pump 2. PTO 3. Inner rod assembly 9. Bolt (Oil Pump) 10. Oil Pump Remove three oil pump tightening bolts and strike them with a plastic hammer (or a wooden hammer) from the truck front side, then remove the oil pump from the PTO. Remove the joint from the oil pump. Notice: If the high-pressure hose could not be removed in Item 7 described previously, remove the oil pump from the high-pressure hose rotating the oil pump at this time. NPA0074E Legend 1. Left frame 2. High-pressure hose 3. Low-pressure hose 4. Wire 5. Truck front 8.
Inner Rod Assembly To remove the inner rod assembly, as shown in the drawing, press the stopper adapter side by a wrench and insert a Phillips screwdriver (large) in the groove of the control cable con- nector. Then rotate it counterclockwise, loosen it, and remove it. Notice: Be sure to press the stopper adapter side and loosen it on the control cable connector side. (Press the stopper adapter side not to rotate the spool valve. Besides, the three-rotation dump truck is in contrast with this.) NPA0076E Legend 1. PTO 2. Bolt 3. Oil pump Installation Steps 1. Oil Pump 2.
Bolt (Oil Pump) Fully coat the oil pump shaft tip groove portion and PTO shaft tip with lithium grease (BESCO L-2 or equivalent). Install the oil pump in the joint. Notice: If the oil pump is rotated and removed from the high- pressure hose when the oil pump is removed, install the oil pump in the high-pressure hose rotating the oil pump and slightly tighten it. NPA0075E