ATV Operation Basic Operating Maneuvers 6. Let the engine warm up. Starting A Cold Engine (350) NOTE: It is very important not to touch or compress the throttle lever during the starting procedures. Active riding and basic maneuvers are the foundation of your ATV ride. Without basic skills, it’s impossible to move to this level— active riding. These are your basic maneuvers: 1. Turn off all electrical accessories (hand warmer, lights, etc.); then rotate the ignition switch key to the first position (ON) leaving the head- lights OFF. Note that the N is indi- cated on the LCD. NOTE: Pump the primer three times when the temperature is at 0° C (32° F) or colder.
To access the primer, the seat and right-side heat shield must be removed. Mounting the ATV Starting the Engine Starting a Cold Engine Shifting Braking/Stopping Parking Dismounting the ATV Mounting the ATV 1. From the left side, grab the left-side handlebar, apply the brake, and put your left foot on the footrest. 2. Grab the right-side handlebar. 3. Swing your leg over the seat and set your right foot down on the right- side footrest. 4. Get seated in a comfortable position. 5. Always keep your feet planted on the footrests. Starting the Engine Always start with the ATV on a flat, level surface. Carbon monoxide poisoning can kill you, so keep your ATV outside while it’s running.
Follow these steps to start it up: 1. Mount the ATV and sit down. 2. Engage the parking brake. 3. Shift into neutral.. 4. Turn on the ignition. 5. Press the starter button. CAUTION Do not run the starter motor for more than eight seconds per start- ing attempt. The starter motor may overheat causing severe starter motor damage. Allow 15 seconds between starting attempts to allow the starter motor to cool. 25 25 25 25 Division II - Operation/ Maintenance 735-887C 738