10. Turn the engine off and wait approx- imately one minute. Recheck the oil level. 11. Inspect the area around the drain plug and oil filter for leaks. Front Differential and Rear Drive Gear Lubricant (Inspecting/Changing) KC0051A 3. Remove the drain plug from the bot- tom of the engine and drain the oil into a drain pan. Inspect and change the gear lubricant in each according to the Service Booklet. When changing the lubricant, use approved SAE 80W-90 hypoid oil and use the following procedure. 1. Place the ATV on level ground. 2. Remove each oil filler plug. 3. Drain the oil into a drain pan by removing in turn the drain plug from each. 733-441A 4.
Remove the oil filter plug from the filter mounting boss (located on the front-right side of the transmission case) and allow the filter to drain completely. 5. Using the oil filter wrench and a ratchet handle (or a socket or box- end wrench), remove the old oil fil- ter and dispose of properly. Do not re-use oil filter. NOTE: Clean up any excess oil after removing the filter. CF107B 6. Apply oil to the new filter O-ring and check to make sure it is posi- tioned correctly; then install the new oil filter. Tighten securely. 7. Install the oil filter drain plug and tighten securely. CF106C 4. After all the oil has been drained, install the drain plugs and tighten securely. 8.
Install the engine drain plug and tighten it securely. Pour the recom- mended oil in the filler hole. Install filler plug. CAUTION 9. Start the engine (while the ATV is outside on level ground) and allow it to idle for a few minutes. Inspect the oil for any signs of metal filings or water. If found, take the ATV to an authorized Arctic Cat ATV dealer for servicing. 50 50 50 50