Tire Replacement 7. Tighten the nuts in a crisscross pat- tern to 4.4 kg-m (32 ft-lb). The ATV has low-pressure tubeless tires. Air is sealed by the contact surfaces of the inner wheel rim and the tire bead. If either the inner wheel rim or tire bead is damaged, air may leak. Be extremely careful not to damage these areas when replacing tires. 8. Remove the jack. Light Bulb Replacement The wattage rating of each bulb is shown in the chart. When replacing a burned bulb, always use the same wattage rating. It is very important to use the proper tools when repairing or replacing tires to prevent damage to the tire bead or wheel rims.
If proper tools and related items are not available, have this maintenance per- formed by an authorized Arctic Cat ATV dealer or a qualified tire repair station. CAUTION When breaking the tire bead loose from the wheel, be extremely careful not to damage the inner wheel sur- face or the tire bead. ! WARNING Headlight NOTE: The bulb portion of the headlight is fragile. HANDLE WITH CARE. When replacing the head- light bulb, do not touch the glass portion of the bulb. If the glass is touched, it must be cleaned with a dry cloth before installing. Skin oil residue on the bulb will shorten the life of the bulb. Use only Arctic Cat approved tires when replacing tires.
Failure to do so could result in unstable ATV operation. Division II - Operation/ Maintenance Tubeless Tire Repair Should a leak or flat tire occur due to a puncture, the tire may be repaired using a plug-type repair. If the damage is from a cut or if the puncture cannot be repaired using a plug, the tire must be replaced. When operating the ATV in areas where transportation or service facilities are not readily available, it is strongly recom- mended to carry a plug-type repair kit and a tire pump along. Wheels 1. Park the ATV on level ground and engage the brake lever lock. To replace the headlight bulb, use the fol- lowing procedure. 1.
Remove the wiring harness connec- tor from the back of the headlight. 2. Grasp the bulb housing, turn it coun- terclockwise, and remove the bulb. 3. Install the new bulb into the housing and rotate it completely clockwise. 2. Loosen the lug nuts on the wheel to be removed. 4. Install the wiring harness connector. When replacing the headlight bulb, be careful not to touch the glass portion of the bulb. Grasp the new bulb with a clean cloth. CAUTION 3. Elevate the ATV. 4. Remove the lug nuts. 5. Remove the wheel. 6. Install the wheel and install the lug nuts. License Plate Light To replace the license plate bulb, use the following procedure.
59 59 59 59 Headlight 12V/35W/35W Taillight/Brakelight 12V/5W/21W License Plate Light 12V/5W Turn Signal - Front 12V/10W Turn Signal - Rear 12V/5W Position Light - Front 12V/5W CAUTION Use only specified bulbs indicated in the chart as replacement bulbs.