Preparation after Storage Taking the ATV out of storage and cor- rectly preparing it will assure many miles and hours of trouble-free riding. Arctic Cat recommends the following procedure to prepare the ATV. 7. Check the entire brake systems (fluid level, pads, etc.), all controls, headlights, taillight, brakelight, license plate light, front and rear turn signals, and headlight aim; adjust or replace if necessary. 1. Clean the ATV thoroughly. 2. Clean the engine. Remove the cloth from the exhaust system. 8. Check the tire pressure. Inflate to recommended pressure as necessary. 3. Check all control wires and cables for signs of wear or fraying. Replace if necessary. 9.
Tighten all nuts, bolts, cap screws, and screws making sure all cali- brated nuts, cap screws, and bolts are tightened to specifications. 4. Change the engine/transmission oil and filter. 10. Make sure the steering moves freely and does not bind. 5. On the 425, check the coolant level and add properly mixed coolant as necessary. 11. Check the spark plug. Clean or replace as necessary. 12. Follow the recommendations found in the Starting the Engine sub-sec- tion in this manual. 6. Charge the battery; then install. Con- nect the battery cables making sure to connect the positive cable first. CAUTION Before installing the battery, make sure the ignition switch is in the OFF position.
62 62 62 62