OM2032 03/13 Safety - Section 20 Page 20-5 Fire Prevention Thoroughly remove wood chips, leaves, paper and other flammable items accumulated in the engine compartment. Failure to do so could result in a fire. In Operator’s Cab - Before Starting The Engine DO NOT leave tools or spare parts lying around or allow trash to accumulate in the cab of the truck. Keep all unauthorized reading material out of the truck cab. Keep the cab floor, controls, steps, and handrails free of oil, grease, snow, and excess dirt. Check fuel, lubrication, and hydraulic systems for leaks. Repair any leaks. Clean any excess oil, fuel or other flammable fluids, and dispose of properly.
Check the seat belt, buckle and hardware for damage or wear. Replace any worn or damaged parts. Always use the seat belts when operating a machine. Ensure a fire extinguisher is present and in proper working condition. Read and understand the contents of this manual pertaining to safety and operating instructions with special attention. Become thoroughly acquainted with all gauges, instruments and controls before attempting operation of the truck. DO NOT operate the machine near open flames. Read and understand the warning and caution decals in the operator's cab. Preparing For Operation Always mount and dismount while facing the truck.
Never attempt to mount or dismount the truck while it is in motion. Always use handrails and ladders when mounting or dismounting the truck. Ensure the steering wheel, horn, controls and pedals are free of any oil, grease or mud. Check operation of the windshield wiper, condition of wiper blades, and check the washer fluid reservoir level. Check the deck areas for debris, loose hardware, and tools. Be familiar with all steering and brake system controls, warning devices, road speeds and loading capabilities, before operating the truck. Check for people and objects that might be in the area. Remove any obstructions and wait for any personnel in the area to disperse.
Become familiar with and use all protective equipment devices on the truck and ensure that these items (anti-skid material, grab bars, seat belts, etc.) are securely in place. Mirrors, Windows, And Lights Remove any dirt from the surface of the windshield, cab windows, mirrors and lights. Good visibility may prevent an accident. Adjust rear view mirrors to a position where the operator can see best from the operator's seat. Ventilation In Enclosed Areas If any glass or light should break, replace it with a new part. If it is necessary to start the engine within an enclosed area, provide adequate ventilation. Exhaust fumes from the engine can kill.
Ensure headlights, work lights and taillights are in proper working order. Ensure that the machine is equipped with the proper work lamps needed for the operating conditions.