Operator Cab and Controls - Section 32 08/11 OM3211 Page 32-14 Display Panel later in this section. RH Control/Indicator Panel (Pod) LH Control/Indicator Panel (Pod) RH control/indicator panel (3, Figure 32-6), located to the right of the steering wheel, contains the following: LH control/indicator panel (5, Figure 32-6), located to the left of the steering wheel, provides an array of indicator/monitor lights and three switches. For detailed information on this assembly, refer to LH Control/Indicator Panel (Pod) later in this section.
Cold Weather Starting Aid (Ether Injection) Switch Starting aid switch (1, Figure 32-7) is an ON/OFF type rocker switch that is spring-loaded to the OFF position. Ladder Light Switch Ladder light switch (6, Figure 32- 6) turns the ladder lights on or off after or before using the ladder. A similar switch is available at ground level to turn the ladder lights on or off. When the outside temperature is below -5°C (23°F), depress the top of this switch and hold for 2-3 seconds before starting the engine. The cold starting aid atomizes ether into the engine intake manifold. Head Light Switch Refer to Keyswitch - START for further details regarding the use of this switch.
The instrument panel lights, clearance lights, and the head- lights are controlled by this three position rocker type switch (7, Figure 32-6). OFF is selected by pressing the left side of the switch. Press the right side of the switch until it reaches the first detent (middle) to select the panel, clearance, and tail lights, only. Press the right side of the switch again, until it reaches the second detent to select the headlights, as well as panel, clearance, and tail lights. DO NOT push the ether injection switch after the engine has started! SERIOUS DAMAGE TO THE ENGINE MAY OCCUR! RH Control/Indicator Panel (Pod) OFF These are rocker type switches.
ON The OFF and ON positions are RH control/indicator panel (3, Figure 32-6), located to marked with these symbols. the right of the steering wheel, provides an array of switches and controls. For detailed information on this assembly, refer to RH Control/Indicator Panel (Pod) later in this section. BackUp/Deck Light Switch Backup/deck light switch (8, Fig- ure 32-6) allows backup lights to Center Display Panel be turned on providing added visibility and safety when the Center display panel (4, Figure 32-6) provides an transmission range selector lever array of gauges and monitors, with an odometer (see Operator Controls) is not in module) and a service/hour meter module.
For the REVERSE position. Backup/deck light switch (8, Fig- ure 32-6) allows backup lights to be turned on providing added visibility and safety when the transmission range selector lever (see Operator Controls) is not in the REVERSE position.