OPERATION 3.4 ELECTRONIC MONITORING AND CONTROL SYSTEM ECS 3.4.2 OPERATING THE ELECTRONIC MONITORING SYSTEM 1.0 TEXT DISPLAY (A) with integrated KEY BOARD (B) illust. Z25237 After switching on the Shovel’s key operated main switch, the fol- lowing introductory messages will be displayed on screen (A): 1 st . # Please be Safety Conscious when working! This message will be displayed for approximately 10 seconds. 2 nd . |QUI| Did you check the Operating Safety of the Shovel? Press the ”QUI” key (10) to acknowledge this message. . 3 rd . |QUI| Did you do Maintenance according to the Ser- vice Literature? Press the ”QUI” key (10) to acknowledge this message.
Thereaf- ter the basic ECS display normally automatically appears on the screen (A) if no information - or fault messages are present. Present information - or fault messages overwrite the introductory messages no. 2 and 3. -0- Date h: M1 *1) 1/min: Time M2 *2) 1/min: *1) M1 = Short form for Rear Engine on counterweight side designated as Engine 1. *2) M2 = Short form for Front Engine on Operator’s cab side designated as Engine 2. All messages related to one of the two engines, their connected cooling systems and pump distributor gears are identified by the figure 1 or 2. Example of an engine related message: Fault No. 560: (563) $h: Shut down of engine 1 :
oil pressure at low idle too low Help: Message through sensor B1- 1 . This message applies to the rear engine on counterweight side ”Engine 1”. 101