General Information 00 M1 Maintenance Interval Operations: 00–06 The M1 Maintenance Interval Operations tables list all maintenance operations that are to be performed at the M1 maintenance interval. Maintenance opera- tion numbers are reference numbers used to help you find detailed instructions in this manual on the maintenance operations to be performed. IMPORTANT: After performing all operations listed in this table, perform all daily, weekly, and monthly maintenance operations listed in the "Pretrip and Post-Trip Inspections and Maintenance" chapter of the Century Class® Driver’s Manual .
Maintenance Operation Number M1 Maintenance Interval Operations for Service Schedules I, II, and III Check 00–04 Lubrication and Fluid Level Check (includes the following):
Eaton Fuller Clutch Release Bearing Lubrication Fifth Wheel Lubrication Trailer Electrical Connector Lubrication Suspension Lubrication Knuckle Pin Lubrication, Dana Spicer Axles Tie Rod Lubrication, Dana Spicer Axles Driveline Lubrication Dana Spicer Camshaft Bracket Lubrication Dana Spicer, Haldex, and Gunite Slack Adjuster Lubrication Cab Tilt Pump Reservoir Fluid Level and System Check Door Seal, Door Latch, and Door Hinge Lubrication Hood Rear Support Lubrication 13–01 Air Compressor Inspection 20–03 Fan Clutch Check (noise emission control) 31–01 Fifth Wheel Inspection 31–05 Premier 690 Coupling Inspection 33–11 Steer Axle Hub Cap Vent Plug Inspection 40–02 Tire Check 41–01 Driveline Inspection 42–07 Meritor Camshaft Bracket Lubrication 42–10 Brake Inspection 49–01 Exhaust System Inspection (noise emission control) 42–11 Versajust Slack Adjuster Inspection and Lubrication * * Complete this procedure every 25,000 miles (40 225 km), 3 months, or 500 operating hours, whichever comes first.
Table 10, M1 Maintenance Interval Operations for Service Schedules I, II, and III Maintenance Operation Number M1 Maintenance Interval Operations for Service Schedule IV Check 13–01 Air Compressor Inspection 20–03 Fan Clutch Check (noise emission control) 31–01 Fifth Wheel Inspection Century Class Trucks Maintenance Manual, August 2017 00/11