Engine Operation 3.2 Starting © 25 746 2 without cold start assistance Where possible, disengage the clutch to separate the engine from any driven parts. Move speed control lever 1 into idle position. Move cut-out handle 2 in direction of “I” and start. Regarding electric starting with a solenoid, the cut-out handle 2 is pulled in direction “I” and held when current is flowing. The charge pilot light and the oil pressure pilot light go out. Before starting, make sure that nobody is standing in the imme- diate vicinity of the engine or driven machine. After repair work: Check that all guards have been replaced and that all tools have been removed from the engine.
When starting with glow plugs, do not use any other starter substance (e.g. injection with start pilot). Risk of accident! Caution: If the speed regulator has been removed, the engine must not be tested under any circum- stances: disconnect the battery! Do not actuate the starter for more than 20 seconds. If the engine does not catch, wait a minute then try again. If the engine does not catch after two at- tempts, refer to the Diagnosis Chart (see 7.1). 3.2.1 Electric Starting © 2001 3 © 35 588 0 35 588 0 © 25 746 2 © 25 746 2