Service and Maintenance 6.7 Accessories © 25 895 0 © 25 896 0 6.7.1.2 Check Electrolyte Level Remove sealing caps 1. If testers 2 are present: Electrolyte level should reach the base of these. Without testers: The electrolyte level should be 10-15 mm above the top of the plates. If necessary, top up with distilled water. Screw sealing caps back in. Keep battery clean and dry. Undo dirty clamps. Clean terminal posts (+ and -) and clamps of the battery, and grease with acid-free and acid-resistant grease. When reassembling, ensure that clamps make good contact. Tighten clamp bolts hand-tight.
6.7.1 Battery 6.7.1.1 Checking battery and cable connectors © 2001 6 © 25 895 0 © 25 895 0 © 24 232 3 © 24 232 3 © 25 896 0 © 25 896 0