4.6 LUBRICATION AND MAINTENANCE SCHEDULE MAINTENANCE (1) Perform maintenance according to separate Engine Operation an Maintenance Manual filed in volume 2 binder. (2) Perform inspections according to the separate Manual ”FIRE SUPPRESSION SYSTEM” filed in part 3 of this binder. (3) Perform inspections according to the separate Manual ”OPERATING INSTRUCTIONS AC” filed in part 3 of this binder. Carry out initial service according to item 4.6.1.
292 Service Intervals Service Point Service See Every 1000 operating hours or every 6 months High strength bolt connections Check for correct tightening torque and security page 367 Hydraulic system Replace return and pressure fil- ter elements Clean or replace high pressure filter elements Replace breather filter elements Drain sediments page 417 PTO’s (Pump distributor gears) Swing gears and Travel gears Oil sample analysis page 431 Signal horn compressor Clean and lubricate page 433 Hydraulic track tensioning system Check pressure accumulators page 435 Water filter for hand wash sink in Operator’s cab Replace carbon filter cartridge page 437 Engine Maintenance (1) Fire suppression system Maintenance (2) Air conditioning Inspect the complete system (3) CAUTION