30 Child Safety INSTALLING CHILD SAFETY SEATS Using Automatic Locking Mode Combination Lap and Shoulder Belts (Front Passenger and Rear Outboard Seating Positions) WARNING: Children 12 and under should be properly restrained in the rear seat whenever possible. WARNING: Depending on where you secure a child restraint, and depending on the child restraint design, you may block access to certain safety belt buckle assemblies and/or LATCH lower anchors, rendering those features potentially unusable. To avoid risk of injury, occupants should only use seating positions where they are able to be properly restrained. When installing a child safety seat with combination lap/shoulder belts:
Use the correct safety belt buckle for that seating position. Insert the belt tongue into the proper buckle until you hear a snap and feel it latch. Make sure the tongue is securely fastened in the buckle. Keep the buckle release button pointing up and away from the safety seat, with the tongue between the child seat and the release button, to prevent accidental unbuckling. Place the vehicle seat back in the upright position. This vehicle does not require the use of a locking clip. Perform the following steps when installing the child seat with combination lap/shoulder belts: Note:
Although the child seat illustrated is a forward-facing child seat, the steps are the same for installing a rear-facing child seat. 1. Position the child safety seat in a seat with a combination lap and shoulder belt. 2015 F-650/750 (f67) Owners Guide gf (ownloose) , 1st Printing, December 2013 Canadian_French (fr_can)