Normal Starting Procedure C8.3 Industrial Page 1-6 Section 1 - Operating Instructions Do not operate engine at low idle for long periods with engine coolant temperature below the minimum specification in Maintenance Specifications in this manual. This can result in the following: CAUTION Fuel Dilution of the lubricating oil Carbon build up in the cylinder Cylinder head valve sticking Reduced performance. Jump Starting WARNING Batteries can emit explosive gases. To reduce the possibility of personal injury, always ventilate the compartment before servicing the batteries.
To reduce the possibility of arcing, remove the negative (-) battery cable first and attach the negative (-) battery cable last. CAUTION When using jumper cables to start the engine, make sure to connect the cables in parallel: Positive (+) to positive (+) and negative (-) to negative (-). When using an external electrical source to start the engine, turn the disconnect switch to the OFF position. Remove the key before attaching the jumper cables. To avoid damage to engine parts, do not connect jumper starting or battery charging cable to any fuel system or electronic component. CAUTION This illustration shows a typical parallel battery connection.
This arrangement doubles the cranking amperage. NOTE: Always reference the relevant OEM literature for jump starting procedures. Failure to follow correct procedures can result in damage to the ECM and other electrical equipment.