Ch 2 page 177 TRANSMISSION Place slip bushing (S) onto the output shaft. Assemble cup spring set (1) and L-ring (2). Installation position of L-ring and cup spring set see Figure 546. (S2) Slip bushing, see Figure 546. Figure 546 Preload the compression spring by means of assembly aid (S1) and pressure piece (S2) until the L-ring has engaged into the annular groove. (S1) Assembly aid 860103-01494 (S2) Assembly fixture 850317-00087 (Slip bushing and pressure piece) Generally, a new L-ring has to be installed! Figure 547 Install the needle sleeve 50x58x20 (1) by means of the pressure piece and oil it. The exact installation position is only obtained when using the specified pressure piece (S)!
(S) Pressure piece 850317-00073 Figure 548 Fasten the needle sleeve with snap ring SB 58 (1). Figure 549 SHOP MANUAL CAUTION NOTE