TRANSMISSION Ch 2 page 192 Assemble housing I and housing II Install two adjusting screws. Place O-rings 14x3.5 (1) into the recess and grease them. Wet the locating face with Loctite 574. By means of lifting tackle install housing I (2) until contact. Pay attention that screen sheets of the differential are aligned! (S) Adjusting screws 120702-00080 Figure 599 Install both pins 10x36 (1). Bolt together housing I/housing II by means of the cylindrical screws (2). Tightening torque (M10/8.8x50) MA = 46 Nm See Fig. 620 and 621! Figure 600 Tighten the 3 remaining cylindrical screws. (S) Socket insert 850316-00381 Figure 601 SHOP MANUAL