Ch 2 page 197 TRANSMISSION Install the screw plugs M10x1 with O-ring 8x1.5 (1). Tightening torque MA = 9.5 Nm Figure 618 Retarder Wet the oil pipe (1) with oil and press it into the stato hollow shaft (2) until contact is obtained. Mount O-rings 70x3 (3) onto the stator hollow shaft and grease them. (S) Driver tool 850317-00089 Figure 619 Fix two adjusting screws into the stator hollow shaft (1) and press it into the oil supply flange (2) until contact is obtained. Pay attention to the hole pattern! (S) Adjusting screw 120702-00080 Figure 620 Install the slotted pins 12x24 (1). Figure 621 SHOP MANUAL