TRANSMISSION Ch 2 page 240 Assembling of LKV Axle Insert 1. Bolt two 5870.204.040 [Fixing pin] into the crown wheel. 2. Fit ring. WARNING Figure 778 Risk of burn injuries due to contact with hot surfaces. Slight or moderate injury possible.Wear protective gloves. Risk of crushing due to hydraulic tool. Slight to moder ate injury possible. Do not reach into danger area. 3. Heat crown wheel and press onto differential housing until contact is obtained. Figure 779 4. Place thrust washers in the differential housing. Figure 780 5. Insert outer and inner disks so that the grooves on the inner diameter of the inner disks are aligned. For the arrangement refer to the current spare parts list.
The thickness of the disk packages must not exceed a maxi mum of 0.1 mm. Figure 781 SHOP MANUAL