Ch 2 page 263 TRANSMISSION Assemble the power drive shaft connecting engine and transmission (4 screws on engine flange and 4 screws on transmission flange) with torque 141Nm. Figure 845 Adjust rear drive shaft into position on transmission flange. Assemble the rear drive shaft with 2 screws on each side (4 screws) Torque: 141 Nm Figure 846 Attach wires and hoses to their previous state if they were cut. Assemble Cooling hoses, hydraulic hoses and electrical connectors back to original position. Figure 847 Relieve tension on the front frame with 2 jacks then assemble tension bar with 4 bolts (2 on each side) Figure 848 SHOP MANUAL