Ch 2 page 91 TRANSMISSION Disassemble snap ring Flush-mount the snap ring with a screw driver at the 4 installation openings of the washer into the annular groove of the shaft (see arrow (Figure 226)) and at the same time pull off the idler with a three-armed puller. Figure 225 Legend: 1 = Gear 2 = Shaft 3 = Snap ring Figure 226 Remove the gear (1) and disengage the snap ring (2). Figure 227 Remove the shaft (1) from the disc carrier under a hydraulic press. Pay attention to the released shaft (1)! Figure 228 SHOP MANUAL