FITTING AND SETTING INSTRUCTIONS FITTING AND SETTING INSTRUCTIONS 3) 3) 7 4 8 10 9 7 1 3 6 2 5 7609A4BS22 1 Lock nut 2 Setting screw 3 Adjusting screw 4 Counter nut 5 Screw cap 6 Pressure bolt 7 Guiding bolt 8 Bleeding screw 9 Piston 10 Spring pack ц The fitting or adjusting must always be carried out when the brake is cold. The fitting or adjusting must always be carried out when the brake is cold. (1) (1) Η Θ Fitting the brake Fitting the brake Rotate the screw cap (5) in a counter-clockwise direction and unscrew it. Release the lock nut (1) and turn the adjusting screw (2) counter-clockwise until the pressure bolt (6) contacts the piston (9) with the flat surface.
Slide the brake over the brake disc in this condition. Screw the two guide pins (7) into the gearbox in accordance with the fitting instructions. Refer to page 3-171. Connect the pressure. Apply the required release pressure (min. 130 bar) to the brake in order to pre-tension the plate spring pack (10) completely, up to the stop. Carry out bleeding of the brake using the bleed valve (8) . Ι Κ Λ Μ Ν 4-24