Control functions 1. Headlight beam switch “LIGHTS” 2. High beam “HI” 3. Low beam “LO” ESU10691 Auxiliary DC jack The auxiliary DC jack is located in the front panel and can be used for accessories. 1. Thumb warmer adjustment switch ESU12711 Grip warmer/rear shock ab- sorber compression damping and thumb warmer adjustment switches These switches are used to adjust the grip warmer, rear shock absorber compression damping and thumb warmer levels. See “Fuel meter, grip warmer level indicator, rear shock absorber compression damping level indicator, and thumb warmer level indi- cator” on page 12 for detailed information. TIP The auxiliary DC jack cannot be used if the engine is not running.
To use the auxiliary DC jack 1. Start the engine. 2. Open the auxiliary DC jack cap, and then insert the accessory power plug into the jack. 1. Auxiliary DC jack cap 2. Auxiliary DC jack 1. Grip warmer/rear shock absorber compres- sion damping adjustment switch 3. After using the auxiliary DC jack, be sure to remove the accessory power plug from the jack and to close the auxiliary DC jack cap. 17