AT Commands User Manual integer type value indicating: − 0: disable time zone change event reporting (default) − 1: enable time zone change event reporting. : integer value indicating the time zone. may be: − 0 disable +CME ERROR: result code and use ERROR instead. − 1 enable +CME ERROR: result code and use numeric values. − 2 enable +CME ERROR: result code and use verbose values. Note: in case of selected value +CMEE=2, meaning formatting the error result code as +CME ERROR: with as verbose value, the following convention is valid:
if the error result code is related to a parameter not covered by the GSM/ETSI or Teltonika specification the value ="operation not supported" shall be used if the TA is in a state which not allow to perform the entered command, the value ="operation not allowed" shall be used. defines the AT command including the prefix AT. The text does not contain the sequence 0 or OK . 20 5.21 Report mobile termination error +CMEE Command syntax Description AT+CMEE=[ ] AT+CMEE=[ ] This set command enables or disables the use of result code +CME ERROR: as an indication of an error relating to the functionality of the MT. When enabled, MT related errors cause +CME ERROR:
final result code instead of the regular ERROR final result code. ERROR is returned normally when error is related to syntax, invalid parameters or TA functionality. Read command +CMEE: OK AT+CMEE? Test command +CMEE: (0-2) i.e. list of supp. s OK AT+CMEE=? 5.22 List all available AT commands +CLAC Command syntax Description AT+CLAC AT+CLAC This execution command causes the MS to return one or more lines of AT commands that are available for the DTE user. Each line contains one AT command. The presentation of commands respects the order in the AT-manual. Test command OK AT+CLAC=?