OPERATION SECTION 1 Page 3 INSTRUMENTS AND CONTROLS MONITOR PANEL L This monitor system consists of monitor lamp groups (A B C), meter group D and warning lamp E. To check the monitor system, turn the starting switch to ON before starting the engine. Then all the monitor lamps, the gauges and the warning lamp light up for about 3 seconds and the alarm buzzer sounds for about 1 second. Three figures, 133, are displayed on the speedometer while the monitor system is being checked After that all lamps go off and the buzzer stops. If any monitor lamp does not light up, ask your distributor to inspect that monitor lamp.
When the starting switch is turned to ON, if the directional lever is not at neutral, the warning lamp will flash and the alarm buzzer will continue to sound. If this happens, return the lever to neutral The lamp will go out and the buzzer will stop. To check the monitor immediately when the engine is stopped, wait for at least 30 seconds after the engine is stopped.