MAINTENANCE SECTION 2 Page 30 Rear Stop the machine so that drain plug (6) of the final drive is at the bottom Remove oil filler plug (5) and drain plug (6). and drain the oil. After draining the oil, clean drain plugs (3), (4) and (6). then install them. Add oil to the specified level through the oil filler ports (l), (5) of the axle housing and left and right final drives. Check the oil level and ensure that it is correct. (Refer to WHEN REQUIRED.) Use the same procedure to change the oil for the front and rear axles. I The type of lubricant used depends on the ambient temperature. Select according to the table “FUEL, COOLANT AND LUBRICANTS”. Refill capacity: 69 (each axle)