Section 3 Dimensions DIMENSIONS This section has been designed to provide enough information to successfully layout chassis in the body planning process. Optional equipment may not be depicted. Please contact your local Kenworth dealer if more dimensional information is desired. ABBREVIATIONS Throughout this section, and in other sections as well, abbreviations are used to describe certain characteristics on your vehicle. The chart below lists the abbreviated terms used. TABLE 3-1. Abbreviations Used TURNING RADIUS Approximate turning radius specifications are listed in the following tables as a general guide. It is important to note that optional components may alter the results. TABLE 3-2.
Turning Radius Table 3-2 continues on next page…
3-1 08/12 CA Back of Cab to Centerline of Rear Axle or centerline of tandems on tandem suspension EOF Frame Rail Overhang Behind Rear Axle – measured from the centerline of tandems FS Front Suspension Height RS Rear Suspension Height WB Wheelbase SOC Side of Cab BOC Back of Cab Model Steering Gear Front Axle Front Wheel Front Tire Rear Suspension Wheel Base (in.) Est Curb to Curb Turning Radius (ft) T800 T800W T800SH Single TAS 65 Dana Spicer E-1202I 12K Accuride 28487 22.5 X 8.25 Bridgestone R287 295/75R22.5 Tandem 52” Axle Spacing 181 28 193 29.5 201 30.5 213 32 220 33 232 34.5 240 35.5 252 37 260 38 272 39.5 280 40.5 291 42 303 43.5 323 46 331 47