SERIES 60 SERVICE MANUAL 1.2.3.2 Pressure Testing of Cylinder Head Perform the following steps to pressure test the cylinder head: 1. Install the test strips (part of cylinder block pressure test kit (J–36223–D) to the firedeck on the cylinder head. See Figure 1-36. Figure 1-36 Cylinder Head Pressure Test Equipment Installation 2. Insert the cylinder head bolts through the cylinder head and test strips. Attach and torque the nuts supplied in (J–36223–D) to 14 N·m (10 lb·ft). 3. Install the thermostat opening cover plate, and gasket to the cylinder head using the bolts provided with the cover plate. See Figure 1-37.
Figure 1-37 Thermostat Opening Cover Plate Installation All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-47