SERIES 60 SERVICE MANUAL 23. Disconnect the harness connector (gray) from the timing reference sensor (TRS) at the lower left corner of the gear case. Remove the TRS from the gear case. Refer to section 2.32.2. 24. Disconnect the harness (black) connector from the synchronous reference sensor (SRS) at the left rear wall of the gear case. Remove the SRS from the gear case. Refer to section 2.30.2. 25. Remove any electrical components, connectors or wiring looms from the engine. 26. With the engine mounted on the overhaul stand, remove all of any remaining subassemblies and parts from the cylinder block. [a] To remove the one piece valve rocker cover, refer to section 1.6.2.
[b] To remove the two piece valve rocker cover, refer to section 1.6.3. [c] To remove the three piece valve rocker cover. Refer to section 1.6.5. [d] Remove the engine lifter brackets, refer to section 1.5.2. [e] Remove the crankshaft pulley, refer to section 1.15.2. [f] Remove the crankshaft vibration damper, refer to section 1.14.2. [g] Remove the accessory drive, refer to section 1.35.2. [h] Remove the gear case cover, refer to section 1.10.2. [i] Remove gear case cover Exhaust Gas Recirculation (EGR) model refer to section 1.11.2. [j] Remove the camshaft drive gear, refer to section 1.29.2. [k] Remove camshaft gear assembly compact gear train refer to section 1.26.2.
[l] Remove the bull gear and camshaft idler gear assembly, refer to section 1.33.2. [m] Remove bull gear and camshaft idler gear compact gear train refer to section1.32.2. [n] Remove the adjustable idler gear assembly, refer to section 1.30.2. [o] Remove adjustable idler gear assembly compact gear train refer to section 1.31.2. [p] Remove the crankshaft timing gear and timing wheel, refer to section 1.34.2. [q] Remove the gear case, refer to section 1.12.2. [r] Remove gear case Exhaust Gas Recirculation (EGR) model refer to section 1.13.1. [s] Remove the camshaft, refer to section 1.28.2. [t] Remove the cylinder head, refer to section 1.2.2. [u] Remove the flywheel, refer to section 1.16.2.
[v] Remove the flywheel housing, refer to section 1.18.2. [w] Remove the oil pan, refer to section 3.11.2. [x] Remove the piston and connecting rod assembly, refer to section 1.21.2. [y] Remove the crankshaft, refer to section 1.7.2. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-11