1.1 CYLINDER BLOCK AND CYLINDER LINER 3. Measure cylinder block bore, at the positions on axis 90 degrees apart. See Figure 1-13. If the diameter does not exceed the dimensions listed in Table 1-1, the block may be reused. NOTE: The above measurements are average gage readings at each position. Also, the out-of-round must not exceed 0.0254 mm (0.001 in.). Figure 1-13 Maximum Cylinder Block Bore Diameters by Location (After Clean-up) Table 1-1 Acceptable Cylinder Bore Diameters (Rev. 2005) All information subject to change without notice. 1-20 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION Location Diameter, mm Diameter, in.
A 149.050 - 149.120 5.868 - 5.871 B 146.050 - 146.120 5.750 - 5.753 C 146.050 - 146.120 5.750 - 5.753