SERIES 60 SERVICE MANUAL [x] To install the valve rocker cover, refer to section 1.6.8 (one piece) and refer to section 1.6.9 (two piece and three piece). [y] Install any electrical components, connectors or wiring looms that were removed during disassembly. [z] Install the SRS, gear case mounted refer to section 2.30.3. [aa] Install the SRS/CMP camshaft gear cover mounted refer to section . [ab] Install the TRS, refer to section 2.32.3. [ac] Install the ECM, refer to section 2.18.3for DDEC I, refer to section 2.17.4for DDEC II, refer to section 2.16.3for DDEC III/IV, and cold plate if required, refer to section 2.16.3. Refer to section 2.15.3 for DDEC V installation.
[ad] Install a suitable lifting device to the engine. See Figure 1-5. FALLING ENGINE To avoid injury from a falling engine, ensure the engine is securely attached to the engine overhaul stand before releasing the lifting sling. [ae] Remove the engine from the overhaul stand. See Figure 1-6. Transfer the engine to a suitable engine dynamometer test stand. Operate the engine on a dynamometer following the Run-in procedure; refer to section 12.7.3.2. Install the engine in the equipment from which it was removed. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-29